Sump Pit and Pump

Sump pumps are used to remove unwanted water collecting in a sump basin.

They will also help alleviate any unnecessary water pressure under the floor which may be causing water to seep up through the key joint of the foundation.

Sump pit and pumps are best suited for older homes which have an inadequate drain system or used during interior drain tile install when no floor drain is available.

Sump Pump Benefits

Helps alleviate static ground pressure in the affected area.

Great back up system when paired with a gasoline generator.

Can help prolong the life of your aging existing interior drain tile if you are not committed to fixing the drain tile issue just yet.

Submersible cast Iron pumps have a great life span and very little maintenance required for upkeep

How it’s done

We install an 18” Diameter by 22” Height Sump basin complete with a lid in the affected area or the lowest point on the foundation floor with plenty of clean drainage stone.
We then hook up a Canadian Made 1/3 Hp Cast Iron submersible pump with 3150 gallons/hour capacity.
From there we securely fasten the discharge pipe complete with a check valve to the wall and pipe it outside onto a cement pad away from the foundation.

FAQ’S

Q: Is the pump noisy?

A: Quite the opposite, submersible pumps are very quiet. When paired with piping that is fastened and a possible insulated bulkhead around them they are virtually silent.

Q: Does the exterior pipe freeze in winter?

A: We only stub our pipe outside the wall a few inches which keeps it from freezing in winter. It is however recommended in summer to add a temporary removable extender that can come off in fall before the freeze.

Q: How long does it take to install a sump pump system?

A: Roughly one whole day. You may need an extension cord or an electrician afterwards to make sure power is near.

Q: Does this come with a warranty?

A: Yes it does! The pump is covered by the manufacturers warranty but the workmanship is covered by our 20-year water shield guarantee.